HP Integrity rx6600 User's & Service Manual page 251

10. Replace the upper SAS backplane board. See
(page 244).
CAUTION: When reconnecting the SAS cables, note the labeling on the channel cables.
Both cables and sockets are clearly marked with the correct channel. Match each cable with
the appropriate socket on the SAS core I/O card. If the cables are mismatched your server
will not boot the OS.
1 1. Plug the SAS data and power cables into the connectors on the SAS backplane boards.
12. Replace the SAS disk drives. See
13. Replace the display board. See
14. Replace the DVD drive. See
15. Plug the USB cable into the connector on the display board.
16. Replace the processor board assembly. See
(page 215).
17. Replace the memory carrier assembly. See
(page 204).
18. Replace the memory carrier assembly cover. See
Cover" (page 180).
19. Replace the top cover. See
20. If rack installed, slide the server completely into the rack. See
Rack" (page 177).
21. Reconnect the power cables and power on the server. See
"Replacing the SAS Backplane Board"
"Replacing a Hot-Pluggable Disk Drive" (page
"Replacing the Display Board" (page
"Replacing the DVD Drive" (page
"Replacing the Processor Board Assembly"
"Replacing the Memory Carrier Assembly"
"Replacing the Memory Carrier Assembly
"Replacing the Top Cover" (page
241).
202).
179).
"Inserting the Server into the
"Powering On the Server" (page
Removing and Replacing the Midplane Board 251
190).
90).