HP Integrity rx6600 User's & Service Manual page 262

Full length PCIe SAS card with RAID capability, supported on HP-UX, OpenVMS, Windows
and Linux,
Full length PCIe SAS card with RAID capability, able to connect to external storage,
supported on Windows and Linux, see
for installation instructions.
9. Installing the New I/O Backplane
IMPORTANT:
serial number and model string information to the new I/O board after installation.
See "Replacing the I/O Board Assembly" (page 225)
10. Powering On the Server. See
Procedure 5 Verification from EFI
1. Respond YES to prompts regarding copying information onto the new board.
2. Verify the serial number and model string data information copied onto the new I/O
board.
a.
b.
c.
3. Enable the TPM.
a.
b.
c.
d.
4. Verify the system board replacement and operation using either the iLO 2 MP or EFI
commands.
1 1. Viewing Warnings
To view warning access the EFI shell and run the info warning command.
12. Verifying I/O cards
To verify the I/O cards access the EFI shell and run the info io command.
Shell> info io
I/O INFORMATION
BOOTABLE DEVICES
Order
-----
1
2
Acpi(HWP0002,PNP0A03,400)/Pci(2|0)/Sas(Addr5000C5000034749D,Lun0)/HD(Part1,Sig4EE76936-BE45-47FA-9AC7-B0ECF2D912F2)
262 Upgrades
see"Installing the HP Smart Array P400" (page 266)
System information is stored on the I/O board assembly. You must write the
"Powering On the Server" (page 90)
Boot to EFI.
Enter service mode using the following command:
Shell> sysmode service
Current System Mode: ADMIN
You are now in SERVICE mode.
Use the sysset command to verify that all values are set:
Shell> sysset
System Information:
Manufacturer: hp
Product Name: server rx3600
Product Number: AB463A
Secondary Product Number is Identical
Serial number: SGH43442VB
Secondary Serial Number is Identical
UUID: 3C33C58E-2E5A-11D8-A33B-4188C0AEFAE2 (Valid)
Secondary UUID is Identical
Product ID: 0x301
Access the EFI Shell.
Enter info sec to display the server security settings on the screen. The TPM is
disabled by default.
Enter secconfig to display a list of configurable security settings.
Enter secconfig tpm on to enable the TPM.
Media Type Path
---------- ---------------------------------------
CDROM Acpi(HWP0002,PNP0A03,0)/Pci(2|1)/Usb(0, 0)/CDROM(Entry0)/HD(Part1,Sig00000000)
HARDDRIVE
"Installing the HP Smart Array P800" (page 270)
for this procedure.
for installation instructions.
for this procedure.