Replacing The Interconnect Board - HP Integrity rx6600 User's & Service Manual

Figure 85 Interconnect Board Removal and Replacement

Replacing the Interconnect Board

To replace the interconnect board, follow these steps:
CAUTION:
material on the back of the board.
NOTE: Use the guide posts located on the chassis and keyways located on the interconnect
board to help you with the interconnect board removal and replacement procedures.
1. Place the interconnect board onto the guide posts.
2. Insert your fingers into the board handle and push the board toward the rear of the chassis
until it plugs into the socket on the midplane board.
3. Replace the lower SAS backplane. See
4. Replace the upper SAS backplane. See
5. Guide the interconnect board air baffle into the chassis and snap it into place.
CAUTION:
Both cables and sockets are clearly marked with the correct channel. Match each cable with
the appropriate socket on the SAS core I/O card. If the cables are mismatched, the server
will not reboot.
6. Reconnect the SAS data and power cables into the connectors on the SAS backplanes.
7. Replace the display board. See
8. Replace the SAS disk drives. See
9. Replace the DVD drive. See
10. Reconnect the USB cable into the connector on the display board.
1 1. Replace the air baffle.
12. Replace the top cover. See
246 Removing and Replacing Server Components
Handle the interconnect board carefully, or you can damage the plastic insulator
When reconnecting the SAS cables, note the labeling on the channel cables.
"Replacing the DVD Drive" (page
"Replacing the Top Cover" (page
"Replacing the SAS Backplane Board" (page
"Replacing the SAS Backplane Board" (page
"Replacing the Display Board" (page
"Replacing a Hot-Pluggable Disk Drive" (page
241).
190).
202).
179).
244).
244).