HP Integrity rx6600 User's & Service Manual page 211

3. Unlatch the cover release lever on the top cover and remove the memory carrier assembly
cover. See "Removing the Memory Carrier Assembly Cover" (page
NOTE: You do not need to fully remove the top cover to service this component; however,
the top cover release lever must be open.
4. Remove the memory carrier assembly. See
(page 203).
NOTE: To avoid damage to the extraction handles, HP recommends rotating the handles
inward and snapping them the locked position when servicing the system DIMMs or any time
the carrier is out of the chassis. Before replacing the memory carrier, press the button to release
the extraction handles. Use the handles to replace the memory carrier into the chassis.
5. Complete the following memory installation prerequisite tasks before installing the memory:
a. Determine the DIMM load order for the 48-DIMM memory carrier. For more information,
see "Memory Load Order" (page
b. Determine the DIMM slots to populate. Use
Slot IDs".
c. Read, understand, and follow the general guidelines to install memory in the server. See
"Memory Loading Rules and Guidelines" (page
6. Lay the memory carrier assembly on side 0 or side 1 so that the memory carrier side that
contains the DIMM slots that require servicing faces upward
7. Remove the memory carrier assembly side cover.
a. Press the release tabs
until the side cover releases from the top center of the assembly.
b. Rotate the side cover slightly to free the tabs from the retaining slots at the base of the
assembly (Figure
c. Lift the side cover off the assembly.
"Removing the Memory Carrier Assembly"
208).
(Figure 68) on both sides of the extraction handle release button
69).
179).
Figure 70: "48-DIMM Memory Carrier Board
209).
(Figure 68).
Removing and Replacing System Memory 21 1