Everex Everdisk Owner's Manual And Reference Manual page 77

Q.
When I boot up, the message invalid drive specification
appears. What should I do?
A.
Make sure you followed the hard disk formatting instructions
in Section 6 of this manual properly. If you have a IBM PC
1, you should run the EVEREX1.EXE program each time you
boot up from DOS.
Q.
After I format the disk, the drive shows a lot of bad
tracks. What should I do?
A.
Make sure you followed the formatting instructions in Section
6 properly; we suggest doing the entire formatting process
again. If you still have a lot .of bad tracks, try removing
some of your expansion boards to determine if an inadequate
power supply is the problem.
Q.
Why does the message drive not ready appear
periodically?
A.
Your power supply may not be adequate enough to power
your hard disk subsystem and expansion boards simultaneously.
Try removing any unused expansion boards and/or consider
upgrading your power supply.
69