Appendix 3: Ev-390 Controller Installation - Everex Everdisk Owner's Manual And Reference Manual

Appendix
3:
EV-390 Controller
Installation
Use the instructions in Section 5 to install the EV-390 Hard
Disk/Floppy controller board. The only change required for
this controller is the installation of a floppy disk ribbon
cable.
To install the hard disklfloppy disk controller:
1.
Remove the floppy disk controller card already in your
system.
2. Attach one end of the 34-pin daisy-cable to the J6
connector on the upper left side of the EV-390 board.
Figure 16: Installing the Floppy Disk Cable
61