Table of Contents
Advertisement
A Note About Unpowered External Subchassis:
There are some external hard disk subchassis that do not
have a built-in power supply. In this case, the power comes
from the system through the hard disk controller. For such
subchassis, plug in a 4-wire power cable from the power
supply to the J5 connector on the controller board; if there
are no spare power cables available, disconnect a 4-wire
cable from your currently installed floppy drive and
connect a "Y" power cable.
Connect one of the 4-wire
connectors to the floppy drive, and the other one to the J5
connector on the controller.
POWER SUPPLY
Figure 14: Connecting the "Y" Power Cable
39
Advertisement
Table of Contents
