Table of Contents
Advertisement
The daisy-chain cable is keyed to prevent installing the
cable backwards.
The untwisted end of the cable
should be attached to the J6 connector. Make sure to
align the cable with pin 1 on the controller; the color
stripe on the cable should be on the right side as you
see the component side of the controller. (See Figure
16.)
3. Connect the cable's middle connector to drive "B", and
connect the end connector to drive "A". (See Figure 16.)
4. Make sure all connectors are fully inserted; do not use
excessive force to install the connectors.
5. Follow the instructions in Section 5.2 and/or 5.3 to
install your hard disk drive(s).
62
Advertisement
Table of Contents
