Everex Everdisk Owner's Manual And Reference Manual page 43

r-.,
5. Connect the 20-pin and 34-pin cables to the hard disk
drives. The cable attached to 12 connects to drive 1, and
the cable attached to 13 connects to drive 2. Make sure
the colored stripe on the cables connect is on the left
side as you face the front of the system. The end
connector of the daisy-chain cable should be connected
to drive 2; the middle connector should be connected to
drive 1. Refer to the following figure.
~/
I
DRIVE 2
DRIVE 1
Figure 11: Installing Two Hard Disk Drives
35