Quick Installation (External Drive) - Everex Everdisk Owner's Manual And Reference Manual

2.2 Quick Installation (External Drive)
1. Configure the SWl jumper on the controller board for
the type of drive you have.
2. Install the controller board in your system.
3. If applicable, connect a 4-wire cable from the power
supply to the controller.
4. Connect the 37-pin cable to the 37-pin connectors on
the controller board's mounting bracket and the
external hard disk subchassis.
5. If applicable, connect the AC power cord to the hard
disk subchassis FIRST, then connect the other end to
the AC wall outlet.
6. Turn on the subchassis FIRST; then turn on the
computer.
7. Format the hard disk drive with the instructions
In
Section 6.
9