Table of Contents
Advertisement
Appendix 6: Questions
&
Answers
Q.
Do I need to change
system motherboard?
the dipswitch settings on the
A.
Normally, you do not need to change the dips witch settings
when you install a hard disk subsystem.
However, if you
removed one of your floppy disk drives so you can install an
internal hard disk drive, check your computer owner's manual
to see how to set the motherboard for one floppy drive
installed.
Q.
When I boot up, the message 1701 hard disk not recognized
comes up. What should I do?
A.
The most likely problem is that your hard disk subsystem is
not securely installed in your computer.
Check to make sure
all cables are properly aligned and securely connected; also,
make sure your controller board is securely installed into the
expansion slot.
"""'.
Q.
After the computer boots up, why does the hard disk
drive motor not spin?
A.
The power cables connected to the
probably not connected properly.
Make
are securely installed to the drive.
hard disk drive are
sure the power cables
68
Advertisement
Table of Contents
