Section
3:
Drive Configuration
Before you can install the hard disk drive into your PC or
XT, you must properly configure the following two areas of
the hard disk:
1.
Configure the drive select switch as drive #1 if it is
your first drive, or drive #2 if it is your second drive.
2. Make sure your drive's terminating resistor is selected
properly.
3.1 The Drive Select Switch
Before you install the hard disk drive, make sure the drive
select switch is configured properly. The drive select switch
enables the controller to select and address the drive. You
r"'.
need to configure the drive select switch to insure that the
drive(s) will be set properly for your system. To change or
confirm the drive's drive select switch, refer to the
following instructions.
10