Table of Contents
Advertisement
5.2 Internal Drive Installation
5.2.1 One Internal Drive
1.
Remove the hard disk controller from the anti-static
bag and confirm the controller is configured for the
drive you
have.
See Section 4.2 for
controller
configuration instructions.
2. Turn OFF the system and remove all power cables
from the system. Clear an area around your computer
to leave plenty of room to work.
3. Install the controller according to the instructions
10
Section 5.1.
4. Make sure the drive select switch and terminating
resistor on the drive have been adjusted according to
the instructions in Sections 3.1 and 3.2.
5. Install the mounting bars onto the disk drive using the
flat head "A" screws as shown in Figure 9.
30
Advertisement
Table of Contents
