Everex Everdisk Owner's Manual And Reference Manual page 60

6.
If your drive has additional partitions, you must format
each partition separately; to choose a partition to
format, press the [F2] key to move the cursor into the
Partitions
menu field, use the cursor keys to select the
partition, and press the [F2] key again to confirm your
selection.
,,-....
7. Once you finish logically formatting each partition,
press the [FlO] key to leave the program; a message will
prompt you to press a key to reboot the system. Make
sure the floppy drive door is open, then proceed to
reboot the system. When your system comes up with a
"C>" prompt, your hard disk is ready for use.
8.
If your disk contains more than one DOS-usable
partition (eg. Extended DOS or Super DOS partitions),
you must create a CONFIG.8YS file in order to use these
extra partitions. To create this file:
a. Boot up your system from your hard disk.
b. Use the DOS COpy command to copy the file
EVDISK.SYS from the EVERDISK utility diskette
to the hard disk.
c. Type in the following lines (DO NOT do this step
if you already have a CONFIG.8YS file on your
hard disk; instead use a text editor to enter the line
device=evdisk.sys
in the CONFIG.8YS file):
,,-....
52