Table of Contents
Advertisement
7.
Connect the 4-pin power cable from a power source
(either the computer's power supply or an additional
power supply) to the drive.
8.
Slide the drive completely into the drive space, and
connect the provided pan head screws to secure the disk
drive mounting bar to the system chassis (see Figure 10).
DO NOT over-tighten the screws or use long screws;
doing so may damage the drive.
9. DO NOT change the switch settings on your system
motherboard unless you removed the floppy disk drive
and replaced it with the hard disk drive; in this case,
refer to your system's manual on how to reset your
motherboard dipswitches for one floppy drive.
10. Reinstall disconnected cables and turn ON your system
with the DOS diskette in drive A.
WARNING: Don't touch the components inside the system
when the computer is ON with the system cover removed;
you may damage the components, and some parts can
cause electrical shock.
11. Format the hard disk using the instructions in Section 6
of this manual.
32
Advertisement
Table of Contents
