Table of Contents
Advertisement
5.2.2 Two Internal Drives
If
you plan to have two internal drives attached the
controller, use the following additional instructions:
1.
Make sure
the controller
is
configured
for
the
installation of two drives.
Refer to Section 4.2 for
instructions on how to configure the controller.
2. Make sure the drive select switch and terminating
resistor on each internal drive are adjusted according to
instructions in Section 3.1 and 3.2.
3. Connect the 20-pin data cable from drive 1 to the 12
connector and the 20-pin data cable from drive 2 to the
13 connector.
Then connect the 34-pin daisy-chain
cable to the 11 connector (see Figure 11).
4.
If
possible, place the drives side by side on top of the
floppy drive or a tape drive. DO NOT try to stack two
hard disk drives on top of one another, as this may cause
the system to overheat!
34
Advertisement
Table of Contents
