Section 2: Getting Started; Quick Installation (Internal Drive) - Everex Everdisk Owner's Manual And Reference Manual

Section
2:
Getting Started
The following Quick Installation subsections are for
experienced PC/XT users. First-time users should follow the
more comprehensive instructions in Sections 3 through 5 of
this manual.
2.1 Quick Installation (Internal Drive)
1. Configure the drive as drive 1 or drive 2, and check if
you need to disable the drive's terminating resistor.
2. Configure the SWl jumper block for the type of drive
you will connect to the controller.
3. Attach the 20-pin and 34-pin ribbon cables to the
controller.
4. Install the controller in your system.
5. Install the drive in your system.
6. Attach the other end of the 20-pin and 34-pin cables to
the drive; attach an available 4-wire power cable from
the power supply to the drive.
7. Reinstall all cables and turn ON the computer.
8. Format the hard disk drive following the instructions in
Section 6.
8