Lanier AP4510 Setup Manual page 329

Message
Snmp over IP over 1394 is ready.
Snmp over ipx is ready.
snmpd start.
started.
The print server received error <error
number> during attempt to log in to the net-
work.Access to the network was denied.Verify
that the print server name and password are
correct.
win2kspd protocol-DOWN (APPEXIT).
win2kspd protocol-UP (APPENTRY).
win2kspd started.
WINS name refresh :Server No Response
WINS name registration:Server No Response
WINS server address0.0.0.0
WINS Server=< WINS server address > NetBI-
OS Name=<NetBIOS name>
WINS wrong scopeID
write error occurred. (diskfull)
write error occurred. (fatal)
Description and Solutions
Communication over IP over 1394 with SNMP
is available.
Communication over IPX with SNMP is avail-
able.
SNMP service has started.
Direct print service has started.
Cannot log in to the file server. The print serv-
er is not registered or the password is speci-
fied. Register the print server without
specifying a password.
NVRAM setting ioctl (SPIO CAPPEXIT) of de-
vice SBP2TSP was set by protocol-DOWN.
SCSI print is not receiving data.
NVRAM setting ioctl (SPIO CAPPENTRY) of
device SBP2TSP was set by protocol-UP.
SCSI print is not receiving data.
SCSI print (SBP-2) service has started.
There has been no response to the update re-
quest from the server. Confirm that the WINS
server address is correct and the WINS server
is working properly.
There has been no response to the registration
request from the server. Confirm that the
WINS server address is correct and the WINS
server is working properly.
The WINS server address has not been speci-
fied. Specify the WINS server address to
match the printer name with WINS.
The printer name has been successfully regis-
tered in <WINS server address>.
The scope ID is wrong.
Specify the correct scope ID.
The hard disk became full while the spool file
was being written.
Wait until enough HDD space becomes avail-
able as printing proceeds.
A fatal error occurred while the spool file was
being written.
Turn the printer off and then on. If this does
not work, contact your service or sales repre-
sentative.
Message List
6
89