Commands List - Lanier AP4510 Setup Manual

❒ The Network Interface Board is reset automatically when the settings are
changed.
❒ When the Network Interface Board is reset, the active print job which has
already been sent to the machine will finish printing. However, jobs that
have not been sent yet will be canceled.

Commands List

Use this command to display remote maintenance use.
Note
❒ Type "help" to see a list of commands that can be used.
msh> help
❒ Type "help command_name" to display information about the syntax of that
command.
msh> help command_name
TCP/IP address
Use the ifconfig command to configure TCP/IP(IP address, subnet mask, broad-
cast address, default gateway address) for the machine.
❖ ❖ ❖ ❖ Reference
msh> ifconfig
❖ ❖ ❖ ❖ Configuration
msh> ifconfig interface_name parameter address
Interface name
ether
sie0
*2
ip1394
*2
fwip0
*1
If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2
Available when the 1394 Interface Unit Type 4510 is installed.
Parameter
(no parameter)
netmask
gateway
broadcast
Interface to be configured
*1
Ethernet Interface
IEEE 1394 Interface
Meaning
IP address
subnet mask
default gateway address
broadcast address
Remote Maintenance by telnet
6
67