Installing Smartnetmonitor For Client - Lanier AP4510 Setup Manual

Windows 2000 Configuration

Installing SmartNetMonitor for Client

For more information about installing SmartNetMonitor for Client, see the Setup
Guide.
After the installation is complete, configure the printer port with SmartNetMon-
itor for Client. ⇒ p.19 "Setting Up the Printer Driver"
2
Deleting the port
The following procedure allows you to delete the printer port. If you want to de-
lete the port which is currently used in Windows, switch the port to another such
as "FILE", then delete it. For more information about SmartNetMonitor for Cli-
ent, see SmartNetMonitor for Client Help.
A A A A
From the [Printers] window, click the icon of the printer which uses Smart-
NetMonitor for Client to print. On the [File] menu, click [Properties].
B B B B
Click the [Ports] tab, and then make sure that the SmartNetMonitor for Cli-
ent port is shown in the [Print to the following port(s)] box.
Remember the port name because this port should be deleted later.
C C C C
Select the [FILE] check box in the [Port] column.
D D D D
Click [OK] to close the Printer Properties.
The port which is currently in use is changed.
E E E E
Open the Printer Properties of the same printer.
F F F F
Select the [Ports] tab.
G G G G
At the [Port] column in the [Print to the following port(s)] dialog box, click to se-
lect the SmartNetMonitor for Client port name as in step
H H H H
Click [Delete Port].
I I I I
When the confirmation message appears, click [Yes].
The port is deleted.
J J J J
Click [Close] to close the Printer Properties.
18
B B B B
.