Setting Up As A Remote Printer - Lanier AP4510 Setup Manual

Setting Up as a Remote Printer

A A A A
Log on to the file server as an Admin or an Admin equivalent.
B B B B
Run the NIB Setup Tool.
Reference
⇒ p.40 "Running the NIB Setup Tool"
C C C C
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
D D D D
Click [IPX protocol].
E E E E
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see the network configuration page to check the MAC address (Network
Address).
F F F F
Make sure that the MAC address and IPX address are correct, and then click
[Finish].
The [NIB Setup Tool] window appears.
G G G G
Click [Configure].
The property sheet appears.
H H H H
Click the [General] tab, and then type the name of the print server into the
[Device Name] box.
I I I I
Click the [NetWare] tab, and then make the following settings.
A A A A In the [Print Server Name:] box, type the name of the print server.
B B B B In the [File Server Name:] box, type the name of the file server in which a
print server is to be created.
Clicking [Browse], you can select a file server among those listed in the
[Browse] dialog box.
NetWare 4.x, 5/5.1 - Advanced Settings
4
55