Lanier AP4510 Setup Manual page 310

Appendix
Note
❒ If you prohibit remote access using TCP/IP and then log out, you cannot use
remote access. If this was a mistake, you can use the control panel to allow ac-
cess by TCP/IP.
❒ When you prevent access via TCP/IP, you are also prevented from using
ip1394, lpr, ftp, rsh, diprint, web, snmp and ipp.
Printer status
The following commands can be used to get information about the current status
of the printer.
msh> command
Command
status
info
prnlog [ID]
6
Note
❒ More information about any print job is displayed when the ID number is
added after the prnlog command.
Reference
For more information about the meaning of the data returned with these com-
mands, see p.82 "Configuring the Network Interface Board".
Network Interface Board configuration settings information
Use the show command to display the Network Interface Board configuration
settings.
msh> show [-p]
Note
❒ Add "-p" to the show command to have the information displayed one screen
at a time.
Reference
For more information about the meaning of the data returned with this com-
mand, see p.82 "Configuring the Network Interface Board".
70
Information that is displayed
Status of printer.
Information about the print jobs.
Information about the paper tray, output tray,
printer language of printer.
Lists the last 16 print jobs.