Lanier AP4510 Setup Manual page 311

System log information
Use the syslog command to display information stored in the machine's system
log.
msh> syslog
Reference
For more information about the displayed information, see p.85 "System Log
Information".
SNMP
Use the snmp command to display and edit SNMP configuration settings such
as the community name.
The 1394 Interface Option Type 4510 supports TCP/IP only.
Note
❒ You can configure from ten SNMP access settings numbered 1–10.
❒ Default access settings 1 and 2 are as follows.
Number
Community name
IP address
Access type
❖ ❖ ❖ ❖ Display
Shows the SNMP information and available protocols.
msh> snmp ?
msh> snmp [-p] [registered_number]
Note
❒ If the -p option is added, you can view the settings one by one.
❒ Omitting the number displays all access settings.
❖ ❖ ❖ ❖ Community name configuration
You can set the community name of the registered number.
msh> snmp number name community_name
Note
❒ The community name must consist of 15 characters or less.
1 2
public admin
0.0.0.0 0.0.0.0
read-only read-write
trap off trap off
Remote Maintenance by telnet
6
71