Lanier AP4510 Setup Manual page 316

Appendix
Job Spool
Use this command to configure Job Spool settings.
Limitation
❒ You can only specify the LPR and IPP protocol.
Note
❒ This machine information cannot reload automatically when you confirm the
Job spool settings on the Web browser. Click [Reload] or [Refresh] on the Web
browser when you want to reload this machine information.
❖ ❖ ❖ ❖ Reference
The job spool setting appears.
msh> spoolsw
❖ ❖ ❖ ❖ Job Spool Setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable the job spool function or "off" to disable it.
6
❖ ❖ ❖ ❖ Clearing Spool Job
If the printer is turned off accidentally during a spool job, you can specify
whether the job will be reprinted when the printer is turned back on.
msh> spoolsw clearjob {on |off}
❖ ❖ ❖ ❖ Protocol Configuration
To change the protocol settings, use the following command. You can specify
the setting for [lpr] or [ipp].
• lpr
msh> spoolsw lpr {on |off}
• ipp
msh> spoolsw ipp {on |off}
Changing the Host Name
Use the hostname command to change the printer name.
msh> hostname [interface_name ] printer_name
interface name
ether
*2
ip1394
*1
If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2
If you install the 1394 Interface Option Type 4510, you can set the command.
76
Interface to be configured
*1
Ethernet interface
IEEE 1394 interface