Getting Printer Information Over The Network - Lanier AP4510 Setup Manual

Getting Printer Information over the Network

Printer current status
You can check the printer's status using the telnet command.
❖ ❖ ❖ ❖ telnet
Use the stat command.
❖ ❖ ❖ ❖ UNIX
Use the lpq or lpstat command or stat parameter of rsh, rcp, or ftp.
Reference
For more information, see "Remote Maintenance by telnet" in the Network
Printing Guide on the CD-ROM labeled "Operating Instructions".
Messages
Call Service Center: SC
Cover Open: Bridge
Cover Open: Duplex Unit
Close Open: Finisher
Cover Open: Front Cover
Cover Open: Lower Right
Cover
Cover Open: Mailbox
Cover open: Right Cover
Empty: Toner
Energy Saver Mode
Error: DIMM
Error: Ethernet
Error & Status Messages on the Control Panel
Description
An error has occurred in the
printer.
The cover of the Bridge Unit is
open.
The cover of the optional Du-
plex Unit is open.
The cover of the Finisher
SR730 is open.
The front cover of the printer
is open.
The lower vertical paper feed
cover is open.
The cover of the Mailbox is
open.
The upper vertical paper feed
cover is open.
The printer is out of toner.
The printer is in Energy Saver
Mode.
An error has occurred in the
printer.
An error has occurred in the
Ethernet Board.
Solution
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
Close the cover.
Close the cover of the optional
Duplex Unit.
Close the cover.
Close the front cover.
Close the cover.
Close the cover.
Close the cover.
Replace with a new toner bot-
tle.
No action is required.
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
First, turn the power switch
off and then on. If the message
appears again, call your sales
or service representative.
5
67