For A Multipath Configuration - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

5. Double-click storportminiportkit_XXXXX.exe in the extracted FC_vXXXXXX directory to run it.
Remarks
"XXXXX" represents the version and must be replaced with a suitable character string.
For details on advanced settings of driver parameters, see the manual of HBAnyware
This completes the installation procedure for a single path configuration. Proceed to 4.3 Changing and
Checking the Setting of Detailed FC Card Information. To use the built-in HDD, shut down the system and then
add the HDD.
For a multipath configuration, proceed to step 6 in 4.1.5 For a multipath configuration.

4.1.5 For a multipath configuration

1. Install the ETERNUS multipath driver.
Insert the CD-ROM disk of the ETERNUS multipath driver, and then run Setup.msi in the Japanese\Server
folder. Follow the instructions on the screen to perform the installation.
Remarks
At this time, leave the secondary FC path cable disconnected.
2. Restore the multipath connection.
After the installation of the ETERNUS multipath driver, a message prompting you to restart the system is
displayed. Select [No], and manually shut down the operating system.
After once powering off the partition, reconnect the cable of the FC path that was disconnected in step 1 and
then start the operating system.
Then, proceed to 4.3 Changing and Checking the Setting of Detailed FC Card Information.
116