Notes On A Multiple Lan Adapter Configuration; Cautions For Using Serverstart - Fujitsu PRIMERGY TX200 S2 User Manual

■ Checking before OS Installation
• When a RAID-configured disk is used
Unnecessary partition information and array configuration information is sometimes written to hard
disks that have been previously used and problems that cannot be anticipate may occur with the same
data.
When connecting a previously used hard disk to this server, perform low level format in advance on
another system and then connect to this server. For details about low level formatting, refer to the
manual that comes with system being used. When performing low level formatting on a hard disk
used in this server, refer to "8.3.6 Formatting Hard Disks Physically" ( pg.258).
• Number of disk units
If the number of actually installed units is smaller than the setting for the number of units (+1 when a
hot spare is specified), installation using ServerStart is aborted because of an error.
When the number of installed disk units is greater than the setting, the disk units are set up according
to the setting. Extra units will be configured as standby disk units. You can add a physical pack later.
For more details, refer to "PRIMERGY ServerBooks" supplied with the server, and "Supplement"
supplied with options.

2.3.3 Notes on a Multiple LAN Adapter Configuration

Using the OS installation wizard of ServerStart, you can configure multiple LAN adapters (network
adapters) on the system. However, there are the following limitations.
●
Adapter Numbers
To configure multiple LAN cards, select the adapter numbers in order of Adapter 1 and Adapter 2, and
enter settings for each adapter. Note that the order of adapter numbers is not necessarily the same as the
order of slots for the installed LAN adapters. This means that the setting for Adapter 1 is not always
applied to the onboard LAN. After installing the OS, check the LAN adapters to make sure that they are
configured as intended.

2.3.4 Cautions for Using ServerStart

■ Operating ServerStart
Most ServerStart operations are performed with the mouse. Items may not be moved with the [Tab] key
or cursor keys. Be sure to use the mouse when operating ServerStart.
■ Ejecting the CD-ROM
Do not eject the ServerStart CD-ROM while ServerStart is running. If the ServerStart CD-ROM is
ejected and inserted again, ServerStart starts up in multiple windows, and settings you have made can be
lost.
PRIMERGY TX200 S2 User's Guide
2
51