Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 66

12. Then, press the [Esc] key to return to the next higher menu.
FIGURE 2.40
13. For a multipath configuration, make the settings described in the sections from 2.2.3 Starting the HBA setup
utility to 2.2.8 Speed and Topology settings for all the HBAs connected to the SAN storage unit LUN from
which the system is started. Also, after installing the operating system and multipath driver, perform the
operation described in 2.2.9 Boot device setting for all the HBAs used to start the system.
When all the settings are completed, press the [Esc] key to return to the UEFI Shell.
Boot device setting
(12)
45