Installing Windows Server 2003 Sp2; Preparing To Install Windows Server 2003 Sp2; Preparing For The Fc Card Driver - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

4.2

Installing Windows Server 2003 SP2

This section describes how to install the Windows Server 2008 SP2.
The same installation procedure also applies to Windows Server 2008 R2 SP2.
All screenshots appearing below are display examples whose contents vary depending on the system
configuration, etc.

4.2.1 Preparing to install Windows Server 2003 SP2

Before the installation, create an ISO image of the I/O controller. To create an ISO image, use ServerView Suite
DVD1 that comes with the PRIMEQUEST 1000 series server or the relevant module downloaded from the
PRIMEQUEST website.
For a multipath configuration, disconnect the secondary cable connected to the server.
Specifically, use a single path configuration (connection with only one FC cable) until you complete the
installation of the operating system and multipath driver.
If the server is in a multipath connection state, the operating system cannot be installed correctly. Manually
disconnect the secondary FC path beforehand.
Remarks
Disconnect all HDDs, including the built-in HDD, other than the HDD with the installation destination LUN.
You can confirm that all of them are disconnected, by starting the Boot Manager Front Page and selecting [Boot
Maintenance Manager] - [Boot Options] - [Change Legacy HDD Boot Priority].
For details on how to check the connected HDDs, see "How to check the connected HDDs."

4.2.2 Preparing for the FC card driver

1. In the Windows environment (Windows2000/XP/2000 Server/2003 Server, etc.), run
***StorportMiniportKit_***.exe stored in ServerView Suite DVD1.
Otherwise, download *** StorportMiniportKit_***.exe from the PRIMEQUEST website, and then run it.
2. When the [Storport Miniport Driver Kit] window appears, click the [Next] button.
3. Enter a destination folder to extract files (C:\Program Files\Emulex is set by default). Then, click the
[Install] button.
Files are extracted.
4. Uncheck the [Start AutoPilot Installer] check box. Then, click the [Finish] button.
117