Applying Settings; Recording The Wwn Of The Fc Port - Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual

2.2.10 Applying settings

Restart the system to apply the changes in the settings
Execute the reset command with the UEFI Shell, or select [Reset] from the [Power Control] window of the
MMB Web-UI to restart the system.
FIGURE 2.41

2.2.11 Recording the WWN of the FC port

According to the design drawing of the SAN boot environment, write down the WWN (World Wide Name),
specific address information assigned to the FC port of the FC card of each server.
To check the WWN, select [1. Setup Utility] from the menu displayed with Emulex FC EFI-Bios Utility, and
then check [Port Name] on the displayed screen.
Remarks
If you are updating FC card firmware (e.g., Boot BIOS), check the WWN after the firmware update.
Restarting the system
46