Fujitsu PRIMEQUEST 1000 Series Environment Configuration Manual page 24


Design the RAID (LUN_R) settings and partition (LUN) for the SAN storage that stores the target
operating system of SAN boot.

Check 1.3 Notes on SAN Boot Environment Design.
2. Making the settings for the PRIMEQUEST 1000 series server

Change the UEFI setting of the PRIMEQUEST 1000 series server and the HBA UEFI/extended BIOS
setting of the FC card or converged network adapter.

Record the WWN for each FC/FCoE port. Also record the WWNN as required.
3. Making the settings for the SAN environment

According to the drawing for FC/FCoE cabling designed in step 1, install the SAN storage and FC switch
or FCoE switch and connect them with cables.

Based on the RAID setting, partition design, and zone information designed in step 1 and on the WWN
information written down in step 2, make the settings for the SAN storage and FC switches or FCoE
switches.

In the setting of the HBA UEFI/extended BIOS of the FC card/converged network adapter included in
the PRIMEQUEST 1000 series server, search for the WWN of the connection destination SAN storage
and set it.
4. Installing the OS and bundled software

Use SVIM to install the OS and bundled software.

Install the multipath driver as required.

According to the drawing for FC cabling designed in step 1, connect the PRIMEQUEST 1000 series
server with the SAN storage/FC switch/FCoE switch.

Register the boot disk (LUN that is the destination of operating system installation) in all of the HBAs to
be used for starting the system.

Specify the priority of the boot devices with the UEFI of the PRIMEQUEST 1000 series server.
3