Reading The Copy And Print Volume On A Network Copier - Oce 3165 Operator's Manual

If after all you decide you want to cancel the printing of the report
Note:
(before quitting the key operator system), simply press the 'Configuration
report' function button again and press the Cancel button.

Reading the copy and print volume on a Network Copier

For administrative reasons, you may display information about how many
prints are generated by print jobs and how many by copy jobs. This shows
whether there is a shift in volume from copy to print jobs. This function,
however, is only available on a Network Copier.
The number of prints counted consist of all pages generated via the DAC (print
jobs, configuration reports, etc.). The number of copies counted are all pages
generated in the copy mode.
Reading the copy counters in the key operator system
Access the key operator system (see page 13).
1
In the 'Basic' section, the current value of the copy and print counters is shown
2
above the function 'Print counters' (see figure 25).
[25] The copy and print volume displayed
When ready, quit the key operator system.
3
40 Océ 3165 Key Operator Manual
15.000
22.500 64 Mb