Switching The Océ 3165 On/Off - Oce 3165 Operator's Manual

Switching the Océ 3165 on/off
The Océ 3165 is switched on and off by means of the green on/off button next
to the paper compartment (see figure 1). When it has not been used for some
time (between 5 minutes and 4 hours, determined by the key operator) the
Océ 3165 will automatically switch off. If it does, users can switch it on again
themselves using the green on/off button, provided the on/off button is not
locked by the optional key switch.
[1] On/off button and key switch
If you do not want other users to operate the copier, you must switch it off
using the key switch. If you do this, you will be the only one who can switch
the copier on again.
Switching on
If available, insert the key into the key switch, turn it to the right into horizontal
1
position and remove it (see figure 1).
Press the green on/off button which will light up.
2
If available, remove the key.
3
The copier takes about 8 minutes to warm up from a cold start. During this
time, you can check the paper stock and, if necessary, reload the paper tray(s).
As soon as the copier has warmed up, the message "Ready to copy" appears in
the display. The copier is now in initial mode, and all settings have been
assigned their standard values.
Switching off
Ensure that there is no job in progress.
1
Introduction
on/off button
key switch
11