External Operation Mode (Operation Using External Input Signals) - Mitsubishi FR-F500 Instruction Manual

3.4.2 External operation mode (Operation using external input signals)

( 1 ) Operation at 60Hz
Step
Power-on Operation mode check
Switch power on and make sure that the operation command indication "EXT" is lit.
(If it is not lit, press the
key to switch to external operation. For operation mode changing, refer to
1
page 49.)
Start
Turn on the start switch (STF or STR).
The operation status indication "FWD" or "REV" flickers.
2
Note: The motor does not start if both the forward and reverse
rotation switches are turned on.
If both switches are turned on during operation, the motor
decelerates to a stop.
Acceleration Constant speed
Slowly turn the potentiometer (frequency setting potentiometer) full clockwise.
The frequency shown on the display increases gradually to 60.00Hz.
3
Deceleration
Slowly turn the potentiometer (frequency setting potentiometer) full
counterclockwise.
The frequency shown on the display decreases gradually to 0.00Hz.
4
The motor stops running.
Stop
Turn off the start switch (STF or STR).
5
( 2 ) External jog operation
Keep the start switch (STF or STR) on to perform operation, and switch it off to stop.
1) Set Pr. 15 "jog frequency" and Pr. 16 "jog acceleration/deceleration time".
2) Select the external operation mode.
3) Switch on the jog signal. Keep the start switch (STF or STR) on to perform operation.
Use any of Pr. 180 to Pr. 186 "input terminal function selection" to assign the terminal used for the jog
signal.
Description
key to choose the operation mode and press the
MODE
OPERATION/CONTROL
57
Image
ON
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
Forward
rotation
Reverse
rotation
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
Forward
rotation
Reverse
rotation
Stop
OFF