Mitsubishi FR-F500 Instruction Manual page 172

2) Set "1" (PU operation mode) in Pr. 79 "operation mode selection".
Example: To change the external operation mode (Pr. 79=2) to the PU operation mode (Pr. 79=1)
Using the key,
MODE
choose the "parameter
setting mode" as in 1).
#Parameter setting mode
FR-DU04
CONTROL PANEL
MON EXT
REV
#Current setting
SET
Flicker
Most significant
digit flickers
Hz
A
SET
V
PU
FWD
#Setting change
Press for
1.5 s
SET
#Setting write
159
Middle digit flickers
SET
7 times
SET
0 to 9
If appears, make sure that the forward
rotation (STF) or reverse rotation (STR) signal
connected to the control terminal is not on.
If it is on, turn it off.
"1" (PU operation mode) has been set in Pr. 79.
If appears, you did not press the
key for 1.5 seconds when writing the setting.
Restart the procedure from the beginning.
Press the key once, press the
restart the setting from the begining.
PARAMETERS
Least significant
digit flickers
9 times
0 to 9
SET
key, and
SET
4