Table 9. Dc Input Rating; Table 10. 250 W Load Ratings - HP Carrier-grade cc2300 Product Manual

DC present / Only Standby Outputs On
Power supply DC outputs ON and OK
Power Supply in Alert Condition
Power supply failure (OTP, OCP, OVP, UV)
DC Input Voltage Specification
The power supply will operate within all specified limits over the input voltage range outlined in
Table 9. The power supply will power-off if the DC input is less than 34 VDC.
Table 9. DC Input Rating
Parameter
Voltage
1
Maximum input current is measured at the lowest input voltage that the power supply continues to operate. This is not to
be used for determining agency input current markings.
DC Output Current Specifications
The combined output power of all outputs will not exceed 250 W. Each output has a maximum and
minimum current rating shown in Table 10. The power supply meets both static and dynamic
voltage regulation requirements for the minimum dynamic loading conditions. The power supply
meets only the static load voltage regulation requirements for the minimum static load conditions.
Table 10. 250 W Load Ratings
PEAK (10sec)
MAX
MIN DYNAMIC
MIN STATIC
Note: The maximum combined power of the 3.3 V and 5 V outputs is 150 W.
cc2300 Carrier Grade Server Product Guide
Minimum Nominal
Tolerance Rating
-38 VDC -48 to –60 VDC
+3.3 V
20A
2.0A
1A
BLINK GREEN
GREEN
BLINK AMBER
AMBER
Maximum
1
Tolerance
-75 V DC
+5 V +12 V
30A
20A 25A
2.0A 1.5A
1A 0A
Maximum Input
Current
13.5 Amps
-12 V 5 VSB
0.5A 1.5A
0A 0A
0A 0A
33