Installing A Cd-Rom Drive - HP Carrier-grade cc2300 Product Manual

Installing a CD-ROM Drive

To install a CD-ROM drive, follow this procedure:
1. Carefully align the connector for the CD-ROM and plug into the drive. Bends at location (A)
greater than 90 degrees can cause damage to circuit traces.
2. Place the CD-ROM drive into the plastic carrier. Make sure to align the two metal mounting
pins on the carrier with the plastic standoffs (A) on the cable and fully insert drive into the
carrier.
3. If no pull-tab is on the CD-ROM drive ZIF connector, install the cable as follows. The carrier
mounting pin at location (A) should go through the mounting hole in the end of the cable as
shown. This prevents the exposed ZIF contacts from potential shorting.
4. Align pin on side of the carrier (A) to fit into the screw hole of the drive for proper
engagement.
cc2300 Carrier Grade Server Product Guide 83