Ricoh DDP 184 User Manual page 154

4. Lock the bottle in place by turning the developer bottle cap about 160 degrees in
the direction shown below.
CAUTION
Hold the developer bottle when you turn the cap so that the bottle is not
turned together with the cap.
5. To start the replacement process, make the following selections from the OCP:
Setup / Consumable / Developer Mix / Supply
The replacement process takes approximately 2 minutes. (Maximum replacement
time is 4
6. Turn the cap back about 160 degrees in the direction shown and remove the
developer bottle.
CAUTION
The Rear Engine cannot perform a toner supply operation with the Top
Cover open. Make sure the Top Cover is closed.
6-10 Care and Maintenance
°
160
!
½
minutes.)
°
160
!