Ricoh DDP 184 User Manual page 134

Message
Developer Error
Check Color E049
Developer Error
Retry Exhausting E048
Developer Error
Retry Operation E047
Developer Mix End of Life
Replace Developer E012
Developer Unit Not Set
Check Developer Unit E037
Drum Unit End of Life
Replace Drum Unit E016
Drum Wrap Sensor Error
Clean Wrap Sensor E018
Drum Wrap
Remove Paper E118
Drum Wrap
Remove Paper E119
Duplex-Always
Elevator Tray Paper Full
Remove Paper E009
Elevator Tray Paper Full
Remove Paper E00A
Enter new password
Enter new password again
Enter service password
Enter system password
Entrance Paper Guide Open
Close Guide
Finisher Front Cover Open
Close Cover E03F
Front Cover Open
Close Cover E043
Fuser Unit End of Life
Replace Fuser Unit E015
Fuser Web End of Life
Replace Fuser Web E014
or E017
5-12 Troubleshooting
Description
The color is different between the toner
unit and the developer unit.
An error occurred when operating the
developer.
An error occurred when replacing the
developer mix.
The developer mixture needs to be
exchanged.
Self Explanatory
The photoconductive drum needs to
be replaced.
The drum wrap sensor level is
abnormal.
Simplex paper is wrapped around the
drum.
Duplex paper is wrapped around the
drum.
Duplex-Always mode is enabled.
The output tray of the Advanced
Finisher is full.
Paper did not stack properly in the
output tray of the Advanced Finisher.
Passwords are for use by System
Administrators and Service
Technicians only.
Passwords are for use by System
Administrators and Service
Technicians only.
You must provide the service
password to gain access to the
selected menu item.
You must supply the system password
to gain access to the selected menu
item.
The Entrance Paper Guide is located
behind Front Cover R of the Publishing
Finisher.
The front cover of the Advanced
Finisher is open.
Self-explanatory.
The fuser unit needs to be replaced.
The fuser cleaning web needs to be
replaced.
Corrective Action
Check the toner and developer units
and replace the incorrect unit.
Retry. If the error occurs again, contact
an authorized Service Technician.
Retry. If the error occurs again, contact
an authorized Service Technician.
Replace developer. Printing will resume
when the developer is replaced.
Set the Developer Unit.
Contact your authorized Service
Technician.
Contact your authorized Service
Technician.
Remove the jammed paper.
Remove the jammed paper.
Contact your System Administrator for
additional information.
Remove paper from the elevator tray.
Remove paper from the elevator tray.
Contact your System Administrator for
additional information.
Contact your System Administrator for
additional information.
Contact your Authorized Service
Technicion if you need access to the
Service menu.
Contact your System Administrator if
you need access to menu items that
are password protected.
Close the guide completely, then close
the cover.
Close the cover.
Close the cover.
Contact your authorized Service
Technician.
Contact your authorized Service
Technician.