Ricoh DDP 184 User Manual page 135

Message
H Pos Sensor Error
Clean H Pos Sensor E01F
Getting Time xxx.xxx.xxx
HCF Open
Close Tray E023
HCF Top Cover Open
Close Cover E046
Heater Off Mode
Hopper Size Unmatch
Load Paper E090
Input Keycode
Input Station Cover Open
Close Cover E044
Inserter
Load xxx E091
Insufficient Disk Space
One Copy Job
Invalid Combination #1
Cancel Job
Invalid Combination #2
Cancel Job
Invalid Folder #xx
Clear Paper Path
Invalid Folder #xx
Cancel Job
Invalid Password
Invalid Time Server Address The specified Time Server is invalid.
Invalid Value
IS Cover Open
Close Cover E044
Description
Image Sensor (H Pos Sensor) is dirty. Clean the Image Sensor.
Getting the time
The door of the high capacity feeder is
open.
Self-explanatory.
Status message
The wrong size paper is loaded in the
hopper.
A valid keycode is required to activate
this feature.
The IS cover is also referred to as the
vertical path cover.
The wrong size paper is loaded in the
inserter
There is not enough space for the
requested operation. Only one copy is
printed.
Incorrect stacker choice requested.
(Cannot deliver to Upper Tray from
Inserter.)
Incorrect stacker choice requested:
(Cannot deliver to Container Stacker
from Inserter.)
The Booklet Finisher cannot perform
the operation.
The Booklet Finisher cannot perform
the operation.
A valid password is required to access
this area of the OCP.
Incorrect value entered.
Self-explanatory.
Corrective Action
None
Close the door.
Close the cover.
Heater off mode is cancelled when
1. the printer is On Line
2. any OCP key is pushed.
3. the consumable counter is reset
from the Web.
4. printer Status is displayed from the
Web.
Load the requested size.
Contact your System Administrator or
authorized Service Technician.
Close the cover.
Load the requested paper size.
Increase disk space or send job
multiple times. See table below
Cancel the job.
Cancel the job.
Remove the remaining paper and
cancel the job.
Cancel the job.
Retry password. If incorrect, contact
your System Administrator.
Check the time server IP address via
the Web Utilities.
Re-enter value.
Close the cover.
Troubleshooting 5-13