Printing Notes - Ricoh DDP 184 User Manual

Printing Notes

Duplex on Transparency
When duplex printing and Transparency, Transparency-pp, or Label stock are
specified at the same time, the job is delivered in simplex mode.
Input Tray PCL
The MBT cannot be included in PCL Tray Auto Select. If the MBT is included,
and even if the specified paper is loaded in the MBT, printing will stop and the
OCP will prompt you to load the correct paper size to the MBT.
Duplex on Tab Stock
When duplex printing and A4 Tab or Letter Tab paper are specified, the job is
delivered in simplex mode.
Single Page Staple
When stapling is specified on a one-page document, no stapling will occur.
Out of Staples
When the Finisher runs out of staples the action will reflect the setup defined in
the Web Utilities (System/Finisher)
Stop: Error message will appear on the OCP.
Continue: Printing will occur with job offset.
Staple Upper Limit
If the staple job contains more than 50 sheets or if the thickness of the paper is
more than 5.0mm, the job is delivered offset with no stapling.
Staple/Collate
If stapling is specified but not collating, the job will not be stapled.
Staple/Face Up
When stapling and face-up delivery are both specified, the job will be delivered
face up and offset with no stapling.
Staple/Upper Tray
When stapling and upper tray are both specified, the job will be delivered stapled
in the elevator tray.
Staple/Paper Type
When staple and transparency or transparency-pp are both specified, the job is
delivered offset with no stapling.
Offset Printing/Upper Tray
When offset printing and upper tray are both specified, the job is delivered to the
Upper Tray with no offset.
Troubleshooting 5-7