Fluke 917X Series Technical Manual page 85

Response: 12.0
This command returns the current gradient zone heater duty cycle.
PROG:DAT?
Read the results of the most recent switch program execution.
Example: PROG:DAT?
Response: 80.0000, 100.0000, 20.0000
This command returns the closed, open, and band temperatures for the last switch test
cycle.
PROG:NAME? [<prog>]
NOTE: Depending on group password setting, this command is conditionally
protected.
Read or select a program name (SEQ1, SEQ2, SEQ3, SEQ4)
Read or select a switch program name (SWIT1, SWIT2, SWIT3, SWIT4).
Read Example: PROG:NAME?
Response: SEQ1
Set Example: PROG:NAME SEQ1
This command is password protected via group 4(program protection).
Issuing program parameter SEQ1 – SEQ4 sets the sequence program. Issuing SWIT1
– SWIT4 sets the switch test program.
PROG:NUMB[?] par[,<n>]
NOTE: Depending on group password setting, this command is conditionally
protected.
Read or set a program parameter (SEQ<n>: SPO<n>, RAMP, DIR, POIN, CYCL,
SOAK, PPO, PSO, PCYC, PDIR)
Read or set a switch parameter (SWIT<n>: CYCL, LOW, HIGH, APPR, RAMP)
Read Example: PROG:NUMB? SPO1
Response: 65
Set Example: PROG:NUMB HIGH,150
This command is password protected via group 4 (program protection).
Digital communication interface
Serial Commands - Alphabetic Listing
77