Fluke 917X Series Technical Manual page 71

Key/Function
CVD
RES
TEST (Probe Test)
SELECT
Probe 1, Probe 2
RESISTANCE
TEMPERATURE (view only)
FOCUS (Focus Select)
FOCUS SELECT
Control, Reference
PROG MENU (Program Menu)
SELECT (Program Select)
PROGRAM
1–4
SETUP (Program Setup)
PROGRAM
1–4
DIRECTION
, 
RAMP RATE
SOAK MINUTES
CYCLES
POINTS
SETPOINT 1
SETPOINT ?
RUN (Program Run)
ACTION
Run, Cont, Stop
PROGRAM (view only)
STATUS (view only)
SWITCH MENU
SELECT (Switch Test Select)
TEST
Notes
SERIAL
RTPW
COEF A
COEF B
COEF C
COEF A4
COEF B4
Callendar Van Dusen coefficients
SERIAL
R0
ALPHA
DELTA
BETA
Set unit to display the resistance of the reference
probe
SERIAL
Select Reference/Control Focus (Control Large/Ref
small or Control small/Ref large. Enabled only when
reference probe option is installed and REF PROBE
is ON in the ENABLE menu, otherwise FOCUS is
disabled.)
(Ramp & Soak) allows unit to be ramped up or down
automatically to a maximum or 8 different set-points
Set unit to go from set-point 1 to 8 or from 8 to 1.
Set the maximum °C/time limit
Time to control at the given set-point (minutes)
Number of times to repeat the given program
Minimum # of set-points is 1 and maximum # of set-
points is 8.
Setup the number of set-points defined in "POINTS"
Controller operation
Menu Structure
63