Fip1.23 Full Stack Error/500 Paper Exit - TallyGenicom 9045N Service Manual

FIP1.23 Full Stack Error/500 Paper Exit

Step
Possible causes:
SENSOR FULL STACK (PL10.1.26)
ACTUATOR FULL STACK (PL10.1.10)
HVPS/MCU (PL12.1.19)
Checking ACTUATOR FULL STACK for operation
1 Does ACTUATOR FULL STACK in paper feed out sec-
tion move smoothly?
Checking SENSOR FULL STACK for operation (1)
Remove EP CARTRIDGE.
Does the number of Sensor/Switch Check increase by
2 one, every time pushing and releasing ACTUATOR
FULL STACK?
Check using Chapter 2 Diagnostic [Sensor/Switch
Check].
Checking SENSOR FULL STACK for operation (2)
Replace SENSOR FULL STACK.
3
Does the problem still occur, after replacing SENSOR
FULL STACK?
Check
1 – 40
Chapter 1 Troubleshooting
Yes
With tool Go to
Replace ACTUA-
step 2. Without
TOR FULL STACK.
tool Go to step3.
Go to FIP1.45
Go to step 3. SENSOR FULL
Replace HVPS/
MCU. End of work
(RRP12.10)
No
STACK.