Rrp5.10 Actuator No Paper (Pl 5.1) - TallyGenicom 9045N Service Manual

RRP5.10 ACTUATOR NO PAPER (PL 5.1)

Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
3) Place the printer down on its left side.
Be careful not to scratch the cover, and do not drop the printer.
4) Open the COVER OPEN (PL 1.1).
5) While lifting up the boss of the HOLDER LEFT (PL 5.1) at the back of the 550 FEEDER ASSEM-
BLY, shift the HOLDER LEFT in the direction of the arrow to remove 3 hooks (Figure 1).
6) Remove the HOLDER LEFT from the SUPPORT NUDGER (PL 5.1) (Figure 1). At the same time,
the ACTUATOR NO PAPER is removed.
SUPPORT
NUDGER
(PL 5.1.12)
(PL7.1.12)
ACTUATOR
NO PAPER
(PL 5.1.14) (PL7.1.14)
SUPPORT NUDGER
(PL7.1.12)
(PL 5.1.12)
HOLDER
LIFT UP
LEFT
(BOSS)
(PL7.1.13)
(PL 5.1.13)
UNDER VIEW
ACTUATOR NO PAPER
(PL7.1.14) (PL 5.1.14)
HOLDER
LEFT
HOOK
LIFT UP
(BOSS)
Figure 1. No Paper Actuator
Chapter 3 Removal and Replacement Procedures (RRPs)
ACTUATOR NO PAPER
HOOK
HOLDER LEFT
(PL7.1.13)
(PL 5.1.13)
1 - 91
HOLDER
LEFT
JG3198AA