Rrp10.12 Switch Duplex (Pl10.1) - TallyGenicom 9045N Service Manual

RRP10.12 SWITCH DUPLEX (PL10.1)

Removal
1) Remove the COVER LEFT (PL 10.1). (RRP10.9)
2) Remove the COVER TOP (PL 10.1). (RRP10.4)
3) Remove the PWBA DUPLEX (PL 10.1). (RRP10.5)
4) Remove the screw (silver, 6mm) securing the HARNESS ASSY DUP EARTH (PL 10.1).
5) Remove the 3 screws (gold tapping, 8mm) securing the BRACKET MOTOR (PL 10.1) to the
COVER HSG DUP (PL 10.1).
6) Remove the SPRING LATCH (PL 10.1) between the LEVER LATCH LEFT (PL 10.1) and
BRACKET MOTOR.
7) Remove the BRACKET MOTOR together with the MOTOR DUPLEX (PL 10.1) and SWITCH
DUPLEX.
When removing the BRACKET MOTOR, be careful not to lose the gears attached to the
COVER HSG DUP.
8) Disconnect the connector of the HARNESS ASSY DUP COVER (PL 10.1) from the connector
(P/J52) of the SWITCH DUPLEX.
9) Release the hooks of the SWITCH DUPLEX, and remove it from the BRACKET MOTOR.
SWITCH DUPLEX
(PL21.1.27)
Replacement
1) Install the SWITCH DUPLEX to the BRACKET MOTOR with hooks.
Chapter 3 Removal and Replacement Procedures (RRPs)
HARNESS ASSY DUP COVER
(PL21.1.31)
HARNESS ASSY DUP EARTH
(PL21.1.28)
COVER HSG DUP
(PL21.1.18)
SPRING LATCH
BRACKET MOTOR (PL21.1.15)
(PL21.1.26)
1 - 181
J23617AA