Rrp5.6 Sensor No Paper (Pl 5.1.38) - TallyGenicom 9045N Service Manual

RRP5.6 SENSOR NO PAPER (PL 5.1.38)
Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
3) Remove the COVER REAR (PL 1.1) (RRP1.1).
4) Remove the CHUTE TRANSFER (PL 6.1) together with the BTR ASSEMBLY (RRP6.9).
5) Remove the 150 FEEDER ASSEMBLY (PL 4.1) (RRP4.1).
6) Remove the screw (gold, 6mm) securing the HOLDER NO PAPER SENSOR (PL 4.1) (Figure 1).
7) Remove the HOLDER NO PAPER SENSOR from the 550 FEEDER ASSEMBLY.
8) Release the hooks securing the SENSOR NO PAPER to the HOLDER NO PAPER SENSOR, and
remove the SENSOR NO PAPER (Figure 1).
9) Disconnect the HARNESS ASSEMBLY TRAY 2 (PL 5.1) from the connector (P/J246) of the SEN-
SOR NO PAPER.
Replacement
1) Connect the HARNESS ASSEMBLY TRAY 2 (PL 5.1) to the connector (P/J246) of the SENSOR
NO PAPER.
2) Install the SENSOR NO PAPER to the HOLDER NO PAPER SENSOR (PL 4.1), and secure it
using hooks (Figure 1).
3) Put the wires of the HARNESS ASSEMBLY TRAY 2 to the notch of the HOLDER NO PAPER
SENSOR as shown in the figure.
4) Install the HOLDER NO PAPER SENSOR to the 550 FEEDER ASSEMBLY using the screw (gold,
6mm).
After tightening the screw, make sure that the wires of the HARNESS ASSEMBLY TRAY
2 are not pinched.
5)Install the 150 FEEDER ASSEMBLY (PL 4.1) (RRP4.1).
Chapter 3 Removal and Replacement Procedures (RRPs)
Figure 1. No Paper Sensor
1 - 84