Rrp4.10 Actuator No Paper (Pl 4.1) - TallyGenicom 9045N Service Manual

RRP4.10 ACTUATOR NO PAPER (PL 4.1)

Removal
1) Remove the COVER REAR 500 (PL 7.1) (RRP7.9).
2) Remove the FUSER ASSEMBLY (PL 6.1) (RRP6.8).
3) Place the printer down on its left side.
Be careful not to scratch the cover, and do not drop the printer.
4) Open the COVER OPEN (PL 1.1).
5) While lifting up the boss of the HOLDER LEFT (PL 4.1) at the back of the 150 FEEDER ASSEM-
BLY, shift the HOLDER LEFT in the direction of the arrow to remove 3 hooks (Figure 1).
6) Remove the HOLDER LEFT from the SUPPORT NUDGER (PL 12.3). At the same time, the
ACTUATOR NO PAPER (PL 4.1) is removed (Figure 1).
SUPPORT NUDGER
(PL5.1.4)
(PL 4.1.4)
SUPPORT
NUDGER
(PL 4.1.4) (PL5.1.4)
ACTUATOR
NO PAPER
(PL 4.1.6)
(PL5.1.6)
LIFT UP
(BOSS)
UNDER VIEW
ACTUATOR NO PAPER
(PL5.1.6)
(PL 4.1.6)
HOLDER
LEFT
LIFT UP
(BOSS)
Figure 1. No Paper Actuator
Chapter 3 Removal and Replacement Procedures (RRPs)
HOLDER
LEFT
(PL5.1.5)
(PL 4.1.5)
HOLDER LEFT
(PL5.1.5)
(PL 4.1.5)
HOOK
1 - 71
HOOK
HOLDER
LEFT
JG3135AA