Paper Exit & Option Face Up Tray - TallyGenicom 9045N Service Manual

5.5 500 Paper Exit & Option Face Up Tray
500 Paper Exit is components for discharging the printed paper out of the printer. 500
Paper Exit enables Face-Up output to the Option Face Up Tray (mounted on the rear
surface of the machine), and output to Option OCT as well as Face-Down output.
MOTOR ASSY EXIT
This motor drives the ROLL EXIT that conveys paper to each output tray. If the
optional DUPLEX is installed, this motor has also a function of reversing and
inserting paper into the Duplex.
ROLL EXIT
This roll transports the printed paper sent out from the Fuser, to the Face-Down
output tray.
ROLL FU
This roll discharges the printed paper sent out from the Fuser, to the Face-Up
output tray.
SENSOR FACE UP OPEN
This sensor detects that the Face-Up print has been selected. If the LEVER GATE
FU is raised, a signal is detected by the Actuator attached to the interlocking GATE
FU, and the Face-Up print mode is set.
SENSOR FULL STACK
This sensor detects that the 500 Exit Face-Down output tray is full, using the
ACTUATOR FULL STACK.
GATE FU
This gate switches the paper transport path interlocking with the LEVER GATE FU.
When the LEVER GATE FU is raised, the GATE FU blocks the normal paper output
path and switches the output direction to the Face-Up output tray.
GATE OCT EXIT
This gate switches the paper transport path interlocking with the LINK GATE OCT.
When the SOLENOID ASSY GATE installed in the optional OCT operates, the
LINK GATE OCT pushed down by the spindle of the SOLENOID ASSY GATE
blocks the normal paper output path and switches the output direction to the OCT
output tray.
Chapter 6 Principles of Operation
6 – 24