Rrp10.8 Roll Dup (Pl10.1) - TallyGenicom 9045N Service Manual

RRP10.8 ROLL DUP (PL10.1)

Removal
1) Remove the COVER LEFT (PL 10.1). (RRP10.9)
2) Remove the COVER RIGHT (PL 10.1). (RRP10.10)
3) Remove the HSG UPPER ASSY (PL 10.1). (RRP10.2)
4) Remove the HSG LOWER DUP (PL 10.1). (RRP10.3)
5) Remove the 2 screws (gold tapping, 8mm) and the SCREW TAPPING (PL 10.1) securing the
COVER DAMPER (PL 10.1) to the COVER HSG DUP (PL 10.1).
6) Remove the COVER DAMPER (PL 10.1) and SPRING DAMPER (PL 10.1) from the COVER
HSG DUP.
For the following step, be careful not to lose any gear, as the working space is limited.
7) Release the hooks of 3 BEARING DUPs (PL 10.1) on the other side of the GEAR ROLL from
the inside, and remove 3 BEARING DUPs from the COVER HSG DUP.
8) Release the hooks of 3 GEAR ROLLs (PL 10.1), and remove them from the ROLL DUP.
9) Remove 3 ROLL DUPs by moving them in the direction of the arrow.
To avoid contamination when removing the ROLL DUP, do not touch the rubber rollers.
BEARING DUP
SCREW TAPPING
(PL21.1.40)
Chapter 3 Removal and Replacement Procedures (RRPs)
ROLL DUP
(PL21.1.17)
BEARING DUP
(PL21.1.19)
SPRING DAMPER
(PL21.1.39)
COVER DAMPER
(PL21.1.38)
1 - 174
COVER HSG DUP
GEAR ROLL
(PL21.1.18)
(PL21.1.20)
GEAR ROLL
G3608AB